JSPT Docs > Screens > Setup

Setup

Learn how to set up the JSPT component. This step is essential for proper functioning of JSPT.

Setup Checklist
  1. To make JSPT  work correctly, we need few basic settings.
  2. For that go to JSPT -» Control Panel -» Setup.
  3. Explanation of each setup point is explained in detail in setup checklist, provided at the right side of setup page.
  4. None of these points should be marked as Cross, these settings are required for proper functionality . (Important)
  5. To perform the step you can click on the link, the JSPT will perform the operation for you.

Unhook

  1. Its an important functionality added in setup checklist .
  2. Unhook is a process of disabling JSPT without Uninstalling it.
  3. This is suggested only when you want to debug some irrelevant issue at your end.
  4. Once you are done with debug process, you can again get to normal settings by checking on cross marks at your setup screen.

Note: If your setup is not complete an error message will be displayed. So, before proceeding please make sure you are done with this section.


  • Monday, 31 May 2010

Comments (0)

Leave a comment

You are commenting as guest.